sheet width 3230 mm
plate thickness 2.5 mm
thickness at "Niro-steel" 1.5 mm
no. of strokes 28 - 42 Hub/min
cutting angle 1.60 Grad
table height 820 mm
distance between columns 3540 mm
Control ELGO 87P
engine output 6.8 kW
weight of the machine ca. 3410 kg.
range L-W-H 4070 x 2070 x 1400 mm
** from a maintenance workshop
** including special accessories (!!)

Equipment:
- robust / motorized swing cut guillotine shears
- break-proof, torsion-free steel welded construction
- compact and clear machine design
- NC electro-motorized back stop
- including NC ELGO "TYP 87P" digital control unit
* adjustable from the front right
* with target/actual value position input
* continuous adjustment over the entire travel range
* rough adjustment via push buttons
* protection of the limit values ??with limit switch
- "Duo-Cut" drive with two dynamic, powerful gear motors
- support table with recessed grips
- hold-down bar with hard rubber strip
- all-steel knife with two cutting edges
- selector switch for single and continuous stroke
- 1x freely movable foot switch
- safety device at the rear
- original operating instructions

** Special accessories included:
- pneumatic sheet holding device for thin sheet metal cuts
- 1x extra long side stop, including support foot + digital stop
- 2x extra long, front support arms
* with "SLIDING" mount - for easy moving
The data for this ad was created with ModulMWS - the software solution of LogoTech oHG.